Proxmox Import Guide

From Virtualizor Wiki
Jump to: navigation, search

Overview

This guide will show you how to Import Proxmox VMs(Openvz/Lxc/Qemu) into Virtualizor.
Your Proxmox control panel will continue to work during and after the import.


Note : Disk type Sata can only be imported from Proxmox to Virtualizor.


The Process

The process to import is as follows :

  • Install Virtualizor on all Proxmox servers from which VMs are to be imported.
  • Add all the newly installed Virtualizor Slaves to the newly installed Virtualizor Master.
  • In the newly installed Virtualizor Admin Panel -> Import -> From Proxmox wizard see the Nodes are showing properly.
  • The Users, Storages and VMs will be imported on a per Node basis by changing the Active Server in the top bar.

Install Virtualizor on Master or each node in the Proxmox cluster

You will need to install Virtualizor on the Proxmox Master or each node in the Proxmox cluster.
This will not disturb Proxmox Servers as Virtualizor uses the EMPS Stack maintained by Virtualizor team which is independent of Proxmox.
You will need to install Virtualizor Proxmox.

Add Slaves

Now you will need to add the Virtualizor Slave Servers installed on top of Proxmox Servers.
The process to add a Slave server is the same as adding any Virtualizor Slave.
Note : If you dont have a Proxmox cluster you can skip this.

Proxmox After Add Slave.png

View Nodes

Proceed to see all the slaves have been added properly.
In the newly installed Virtualizor Admin Panel go to Import -> Import Proxmox wizard and click on the View Nodes utility.

Proxmox Import.png

This utility doesnt import anything. Its just to check which nodes have beed added.
You will have to run this wizard for each slave by choosing the Active Server.
You will see something like the following.

Proxmox Import Nodes.png

Import Users

Click on the Import Users utility.
You will see something like the following.
You will have to run this wizard for each slave by choosing the Active Server.

Proxmox Import Users.png

Import Storages

Click on the Import Storages utility.
You will see something like the following.
You will have to run this wizard for each slave by choosing the Active Server.

Proxmox Import Storages.png

Import VMs

Finally, lets import the VMs.
Click on the Import Virtual Servers utility.
You will have to run this wizard for each slave by choosing the Active Server.

Proxmox Import VM.png

Verify

Now verify that all data has been imported successfully.
Welcome to the Virtualizor family.

Support

We would be happy to help you migrate. Please contact the Virtualizor Team to help you migrate.